500S Display Ebike Error Code | Error Code | Ebike Error Code

Please see Ebike error codes and their corresponding descriptions below:

500s	Error Code	Description
0x04	Throttle Fault	Reconnect the wire of the throttle. Find the throttle wire with the orange connector inside, disconnect it and then reconnect it to restart the throttle. If it still doesn’t work, you need to replace the throttle.
0x08	Motor Hall Defect	Reconnect the motor wire. Find the motor wire near the hub motor, disconnect it, and then reconnect it to restart the motor. If the error code is still on the display, please send an email to after-sales with providing a relevant video, the motor serial, bike serial number, and the motor connector, we will help you replace the motor.
0x03	Brake Failed or Brake Applied While Turning On	Unplug the brake levers one by one to confirm whether it is caused by the left or right brake lever. Please check the instruction video https://www.youtube.com/watch?v=Jwp4VPSr2zU. Try to adjust the screws to see if it can be solved. Please check the instruction video https://youtu.be/Eimq2N6RtoA. If there is still an error code 25, you need to provide the relevant video, bike serial number and contact the after-sales service to replace the brake lever.
0x30	Abnormal Communication	Please do the test according to the video https://www.youtube.com/watch?v=HJf4r-HHfPc&feature=youtu.be. You need to unplug all the plugs including 7 (2 brake levers, throttle, front light, tail light, sensor, motor wire). At this time, the meter should display error code 24 normally. After all unplugging, if code 30 still appears on the display, there is a high probability that it is a controller problem. After all unplugging, if the display shows code 24, then connect the motor cable first. If 30 appears then, it is a motor problem. If there is no error code after connecting the motor, connect other connections in sequence until the error code 30 appears. It means that code 30 is caused by this connection, and this part needs to replace. Then provide the relevant video and bike serial number to contact the after-sales service.
0x06	Low Voltage Protection	Check that your battery is fully charged
0x07	Over voltage Protection	Check your battery voltage. Make sure you are using a 48v or 52v battery.
0x09	Motor Phase Line fault	Check your motor for damage.
0x10	Controller temperature sensor failure	Check your controller for damage
0x21	Speed sensor error	Check that your speed sensor and spoke magnet are both properly installed and there is only 3-5mm clearance between the two

Please help our co-pedalers by voting if this article is helpful or not.